The SuperB Hardware

ESP32 Breakout Overview (The SuperB breakout overview, take note of the locations of "EN" and "IO0")

To place SuperB into bootloader mode, EN must be brought low and returned to high while IO0 is held low. Or, in other words, IO0 must be held low during the EN rising edge. (See depiction below) Graph showing EN and IO0

Use XBee USB Adapter to Flash

For the instructions that follow, the SuperB is connected to the computer with an XBee USB Adapter board (with one modification), available here. Image showing SuperB next to adapter board
Before the board can be used with the SuperB, VREF and DIO11 need to be bridged on the rear of the board as shown below. Image showing jumper wire soldered between pins labelled "VREF" and "DIO11"
At this point the board can be connected to the computer via USB with the RESET and BOOT buttons controlling EN and IO0, respectively. Image showing RESET and BOOT buttons

Use M2 to Flash


results matching ""

    No results matching ""